MKU PA 23CM-250W CU, Power Amplifier
1270 ... 1300 MHz • 250 W
High Power Amplifier for the Amateur Radio Band 23 cm
This linear high power amplifier was developed for producing high frequency energy for accelerators applications.
High power, high efficiency and best linearity are achieved by our high power amplifier for the 23 cm amateur radio band. Compared to tube power amplifiers the used LDMOS transistor operates with a supply voltage of only +50 V DC. High voltage transformers, waiting for tube warm-up and retuning of the tube are the past! The power amplifier can be mounted close to the antenna to avoid power losses caused by long coaxial cable.
High Power Amplifier for the Amateur Radio Band 23 cm
This linear high power amplifier was developed for producing high frequency energy for accelerators applications.
High power, high efficiency and best linearity are achieved by our high power amplifier for the 23 cm amateur radio band. Compared to tube power amplifiers the used LDMOS transistor operates with a supply voltage of only +50 V DC. High voltage transformers, waiting for tube warm-up and retuning of the tube are the past! The power amplifier can be mounted close to the antenna to avoid power losses caused by long coaxial cable.
Technical specifications
Frequency range | 1270..1300 MHz |
Input power | 4 ... 6 W |
Maximum input power | 6 W |
Saturation power | typ. 300 W |
Gain (small signal) | min. 17 dB |
Harmonic rejection | min. 35 W @ 250 W |
ON voltage | +9 ... 14 V DC |
Supply voltage | +50 V DC |
Quiescent current | typ. 0.25 A |
Current consumption | max. 12 A @ 300 W |
Operating case temp. range | -20 ... +65 °C |
VSWR of load | max. 1.8 : 1 |
Input connector / impedance | SMA-female / 50 ohms |
Output connector / impedance | N-female / 50 Ohms |
Case | milled copper, silver-plated |
Dimensions (mm) | 130 x 60 x 20 |
Weight | 730 g (typ.) |
Features
- Milled copper case to provide optimum heat transfer
- 50 V LD MOSFET technology
- High linearity
- High efficiency (up to 50 %)
- Reverse polarity protection
- Monitor output for forward power detection (DC voltage)
- ON / OFF control with DC voltage
Applications
- Research: High Power Amplifier for accelerators
- Analog and digital (COFDM) transmission systems
- Amateur Radio operations (EME, contest)
Important notes
Please notice the following:
- The technical specifications refer to room temperature.
- The power amplifier doesn’t contain any coaxial relays.
- The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
- Further information about dimensioning of heat sinks is available on our FAQ site.
Industrial use
Our power amplifiers of the MKU-series are exclusively intended for amateur radio applications and will only be sold to radio amateurs with a licence. These products are specified for amateur radio requirements and are not designed for industrial applications. Please notice our list of industrial products or ask for a special version.
Downloads