MKU LNA 232 AH, Super Low Noise Preamplifier
2304 ... 2322 MHz
Super Low Noise Preamplifier for DX and EME
Super Low Noise Preamplifier for DX and EME
| Frequency range | 2304..2322 MHz |
| Noise figure @ 18 °C | typ. 0.5 dB |
| Gain | typ. 30 dB |
| Maximum input power | 1 mW |
| Output IP3 | typ. +27 dBm |
| Supply voltage | +9 ... 15 V DC |
| Current consumption | typ. 80 mA |
| Operating case temp. range | -20 ... +65°C |
| Input connector / impedance | N-male, 50 ohms |
| Output connector / impedance | N-female, 50 ohms |
| Case | milled aluminium |
| Dimensions (mm) | 73 x 30 x 22 |
| Weight | 140 g (typ.) |
For many years, this super low noise microwave preamplifier has been used very successful. Many results of Ham Radio Contests proof that! Due to an extremely low noise figure the preamplifier is ideal for tropo DX, EME (earth moon earth operation) and for receiving satellites.
- Extremely low noise figure
- High IP3 for good large signal performance
- Unconditionally stable - no parasitic oscillations in case of poor antenna match
- Reverse polarity protection
- Solder pin for direct power supply
- Male connector at the input for direct connection to antenna or coaxial relay
- Small mechanical dimensions
- Remote power supply via output connector
- Extremely low noise figure
- High IP3 for good large signal performance
- Unconditionally stable - no parasitic oscillations in case of poor antenna match
- Reverse polarity protection
- Solder pin for direct power supply
- Male connector at the input for direct connection to antenna or coaxial relay
- Small mechanical dimensions
- Remote power supply via output connector
- Amplifier does not contain a coaxial relay!
- Maximum input power 1 mW
