MKU 10 G5, 3 cm Transverter
MKU 10 G5, 3 cm Transverter Blockschaltbild / block diagramm Suite

MKU 10 G5, 3 cm Transverter

NEW - NEW - NEW

- Covering full 3 cm amateur radio band from 10000 MHz to 10500 MHz
- Flexible IF choice from 28 MHz to 440 MHz
- Very high spurious and harmonic rejection even at 28 MHz IF
- Low power IF mode


- Easy configuration of the transverter with our Kuhne Suite (works with Firmware V1.1)
net: 545,38
649,00
incl. 19% Vat. plus shipping
Available from stock
RF range10000 ... 10500 MHz
IF range28 ... 440 MHz
IF input power0.5 ... 5 W, adjustable
LO accuracy @ 18 °Ctyp. +/- 0.5 ppm (without ext. ref.)
LO frequency stability (-5 ... +55 °C)typ. +/- 0.5 ppm (without ext. ref.)
Phase noise @ 1 kHztyp. -94 dBc/Hz
Phase noise @ 10 kHztyp. -103 dBc/Hz
Phase noise @ 100 kHztyp. -105 dBc/Hz
Phase noise @ 1 MHztyp. -123 dBc/Hz
Output powermin. 200 mW
Spurious rejectiontyp. 50 dB
Harmonic rejectiontyp. 48 dB
RX gaintyp. 25 dB
Noise figure @ 18 °Ctyp. 1.3 dB
External reference input10 MHz / 2 ... 10 mW (sine or square wave)
Reference input connectorSMA-female, 50 ohms
PTT controlcontact closure to ground or +12 V on the IF-cable
Supply voltage+13.8 V DC (+12 ... 14 V DC)
Current consumptiontyp. 580 mA
Casemilled aluminium
Dimensions (mm)100 x 80 x 14
IF connectors / impedanceSMA-female, 50 Ohms
RF connectors / impedanceSMA-female, 50 ohms (separate RX/TX connectors)
Weight370 g (typ.)
Find a detailed description under downloads.
  • Covering full 3 cm amateur radio band from 10000 MHz to 10500 MHz
  • Flexible IF choice from 28 MHz to 440 MHz
  • Very high spurious and harmonic rejection even at 28 MHz IF
  • Low power IF mode
  • Input for an external 10 MHz reference source
  • Local-Oscillator with high frequency stability VCTCXO
  • IF range for RX and TX independent configurable
  • Big attenuator at the IF input for input power up to 5 watts
  • Fuses are self-resettable (polyfuses)
  • Low noise converter in the receive path
  • Transmit gain and receive gain separately adjustable
  • Control output for additional amplifier stages or a coaxial relay
  • Adjustable sequencer delay
  • PTT can be switched by a voltage on the IF connector or by connecting the PTT pin to ground
  • Detector output (DC voltage) for monitoring the output power

Accessories

References