contact closure to ground or +12 V on the IF-cable
+13.8 V DC (+12 ... 14 V DC)
typ. 1 A (TX)
138 x 63 x 36
IF connectors / impedance
SMA-female, 50 Ohms
RF connectors / impedance
SMA-female, 50 ohms
320 g (typ.)
Now, an external 10 MHz reference frequency can be connected to achieve highest frequency accuracy. This is necessary for EME, WSJT and Tropo DX. The frequency of 10 MHz can be supplied by a highly stable OCXO, a reference oscillator of a frequency counter, a rubidium frequency standard or a GPS controlled frequency source.
If a 10 MHz reference frequency is not available, the internal crystal oscillator of the transverter can be used. This crystal oscillator is frequency stabilized by our 40 °C precision crystal heater QH40A.
A bigger attenuator at the IF input port allows an input power of up to 5 watts. Great large signal performance is achieved by the use of a high-level ring mixer. Self-resettable polyfuses prevent damages of the transverter module, especially if it is used in a portable station. Of course, all the well-tried functions of the old transverter version are kept in the new design!
The small mechanical dimensions of the transverter, which is designed in SMD technology, allow the construction of a small portable station as well as a powerful home station.
New features of the transverter MKU 13 G3
Additional input for 10 MHz reference frequency
Internal stabilized oscillator with precision crystal heater (can be used instead of 10 MHz reference frequency)
High Level Ringmixer with an IP3 of +25 dBm
Higher output power
Bigger attenuator at the IF input for input power up to 5 watts
Fuses are self-resettable (polyfuses)
Well-tried functions and features - based on MKU 13 G2
Super low noise converter in the receive path
Transmit gain and receive gain separately adjustable
Control output for additional amplifier stages or a coaxial relay
PTT can be switched by voltage on the IF connector or by connecting the PTT pin to ground
Detector output (DC voltage) for monitoring the output power