MKU PA 13CM-10W A, GaAs Power Amplifier
2300 ... 2400 MHz • 10 W
Power Amplifier for the Amateur Radio Band 13 cm
This series of power amplifiers for the 13cm band uses GaAs FETs. Due to its linearity the amplifier is usable for all analog and digital modes in amateur radio. Typical examples are SSB, CW, ATV and DATV (digital amateur television).
Power Amplifier for the Amateur Radio Band 13 cm
This series of power amplifiers for the 13cm band uses GaAs FETs. Due to its linearity the amplifier is usable for all analog and digital modes in amateur radio. Typical examples are SSB, CW, ATV and DATV (digital amateur television).
| Frequency range | 2300..2400 MHz |
| Input power | typ. 1 W |
| Maximum input power | 1.5 W (+31.7 dBm) |
| Saturation power | typ. 10 W |
| Gain (small signal) | typ. 10 dB |
| Harmonic rejection | typ. 30 dB |
| Supply voltage | +12 ... 14 V DC |
| Current consumption | typ. 2.5 A |
| Operating case temp. range | -20 ... +55 °C |
| VSWR of load | max. 1.8 : 1 |
| Input connector / impedance | SMA-female / 50 ohms |
| Output connector / impedance | SMA-female / 50 ohms |
| Case | milled aluminium |
| Dimensions (mm) | 80 x 60 x 20 |
| Weight | 140 g (typ.) |
- Detector output (DC voltage) for monitoring forward output power
- Reverse polarity protection
- Suitable for all analog and digital modes (SSB, CW, ATV, DATV)
Please notice the following:
- The technical specifications refer to room temperature.
- The power amplifier doesn’t contain any coaxial relays.
- The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
- Further information about dimensioning of heat sinks is available on our FAQ site.
Our power amplifiers of the MKU-series are exclusively intended for amateur radio applications and will only be sold to radio amateurs with a licence. These products are specified for amateur radio requirements and are not designed for industrial applications. Please notice our list of industrial products or ask for a special version.
